The Honey Fire Inlander is a hybrid wildland favorite. Its sole is not NFPA rated, though its stitching is. Its for the guys who want to try the Honey sole. See what you think. But, not recommended for those that require NFPA boots.
Build your custom boots. Choose your options. See what you like, what you don't understand, read up on our product description page.
Height - 10 inch high from "midsole to top of upper" (heels not included)
Uppers - 8oz to 9oz oil tanned premium leather
Thread - high strength, Technora® fire resistant over 900 °F
Hardware - traditional high quality eyelets and speed hook combination
Insole - genuine oak tanned leather
Midsole - genuine oak tanned leather
Arch support - leather
Sole - NFPA rated Vibram® Red X fire resistant
Maintenance - rebuildable and resolable
Origin - handmade in the USA
Send questions, comments, or other information to email@example.com
Complete in 3 steps
What you’ll need:
Fitsheets, Tailors tape, #2 pencil or same thickness pen (no bumps, rubbers, or curves), Hard flat surface, Someone else to take measurements for you (recommended)
(Use socks that you intend to wear with your boots). *Note: thick or wool socks pair very comfortably with custom leather boots
Place Fitsheet on hard and even surface
Stand with one foot on Fitsheet, the other foot on even surface.
- Note* stand normally with your body weight distributed evenly
Trace your entire foot
-Note *Be sure to hold pen at a 90° angle perpendicular, straight up and down to paper while tracing.
2. Circumference measurements
(Use socks you intend to wear with the boots.)
Sit down on a chair, relax foot on hard flat surface
Wrap tailor’s tape around the circumference of your feet and legs at indicated areas
- Note* wrap the tape snug to comfort, not too tight, not too loose
- Note* during the “ball measurement” be sure to find both inside and outside bones and wrap tape around foot in that area
3. Wall foot length measurement