Purchase, determine sizing, wait for contact according to lead times

About

All leather insoles, midsoles, shanks and heel bases. The highest quality 8 oz oil tanned leather. American made Iron nails, brass eyes and hooks. All Vibram rubber outsoles and heel caps. Along with heavy duty adhesives and wax coated stitching, our boots are hand lasted and doubled stitched through the outsoles. All of this, plus the long hours of detailed craftsmanship backed by over 26 years of experience, is what makes JK Boots the best boot on the market.

Each piece inside of JK Boots is literally the highest of quality in that category. For example leather, we make sure to use the highest quality leathers. Or soles for example; We make sure to use only the best quality soles out there. Its in part to these details that either make a great boot, or an average boot.
Fitsheets

DOWNLOAD FITSHEET CLICK HERE 

UPLOAD FITSHEETS CLICK HERE

 

 

Overview

  1. Download Fitsheet
  2. Mail or scan with printer-only to email us here
  3. Wait for one-on-one fitting consultation with a JK Boots bootmaker

 

Full Instructions

Complete in 3 steps

 

What you’ll need:

Fitsheets, Tailors tape, #2 pencil or same thickness pen (no bumps, rubbers, or curves), Hard flat surface, Someone else to take measurements for you (recommended)

1. Tracings
(Use socks that you intend to wear with your boots). *Note: thick or wool socks pair very comfortably with custom leather boots

Place Fitsheet on hard and even surface

Stand with one foot on Fitsheet, the other foot on even surface.
- Note* stand normally with your body weight distributed evenly

Trace your entire foot
-Note *Be sure to hold pen at a 90° angle perpendicular,  straight up and down to paper while tracing. 

 

2. Circumference measurements

(Use socks you intend to wear with the boots.)

Sit down on a chair, relax foot on hard flat surface

Wrap tailor’s tape around the circumference of your feet and legs at indicated areas
- Note* wrap the tape snug to comfort, not too tight, not too loose
- Note* during the “ball measurement” be sure to find both inside and outside bones and wrap tape around foot in that area

 

3. Wall foot length measurement

1. Take off your shoes and place your heel against a wall
2. Mark then end of your toe with a pencil
3. Measure from the wall to your mark.
4. Complete for right and left, then send info via email

 

 

Mail To: 36 E Wellesley Ave. Spokane WA 99207 USA *recommended method
Or
Scan: scan with a standard printer/scanner ONLY (do not use mobile phone apps or pictures) and email to size@jkboots.com
fit, sheet, fit sheet, size, sheet, paper, measure, measuring, measurements, fitting,